Configuring a mouse

To install a mouse on your system:

1. Install the mouse in the computer according to the manufacturer's instructions.

2. Log in as root, put the system into maintenance mode.

3. Select Mouse/Graphic Input Device from the devices listed by the Hardware/Kernel Manager, or enter the command mkdev mouse.
   

4. Select Install a mouse from the menu.

5. 
   Select the type of mouse you will use from the options listed. When prompted:

   • For a serial mouse, select the port on which the mouse is installed.

   • 
     
     
     
     
     For a bus mouse, select the type of mouse to be installed and its parameters. If you wish to change the default parameters, Take special care when changing the interrupt vector for the mouse. Select an unused interrupt vector. See ``Typical device interrupts''.
     

   • For a keyboard mouse, select the resolution you require. See ``Changing the keyboard mouse resolution setting'' and ``Solving slow or no response from keyboard mice'' for more about high resolution mice.)

   • For wheel mice, select an entry that contains the string ``wheel''.

6. Specify the terminals and multiscreens that are allowed to accept input from the mouse. Do not specify any tty ports where mice are actually connected.
   
   
   
   
   
   You may choose to allow any or all other terminals and console multiscreens to use the mouse. The default associates the mouse with all of the console multiscreens.

   If you install more than one mouse, make sure the terminal specifications for each mouse do not overlap. Only one mouse can be allowed for input on a given tty.
   

   See ``Using a mouse'' for more information on sharing the mouse between several terminals or multiscreens.
   
   
   

7. Relink the kernel to install the mouse driver.
   
   
   
   
   

8. If you have no more changes to make to your mouse configuration, quit the mkdev utility and use the System Shutdown Manager or the shutdown(ADM) command to shut down the system and reboot.