How To Make A DIY Vagina
Materials:
-Lays/Pringles Can
-Foam rubber
-Condom
-1 1/4'' o-ring
-Scissors
-Marker
Procedure:
Empty the chips out of the can. You can use whatever brand
and flavor you prefer, but we like the one shown here for the
container’s ergonomic shape and durable, colorful plastic. Lay
out the foam and trim to fit the length of the container if
necessary. The length of the foam can be up to an inch longer
than the length of the can.
Unroll the condom and drop the O-ring inside. If you use a
lubricated condom, turn it inside out first, so the lube is on the
inner surface.
Lay the condom along the foam with the open end slightly above the
edge, and mark across where the O-ring lays in the condom. Cut the
foam into two pieces along this line.
Roll up the smaller piece of foam and push it into the bottom of the
can. Lay the condom against the shorter edge of the other piece of
foam so that the tip and the O-ring are hanging over one end and the
open top of the condom is hanging over the other. Roll up the foam
with the condom inside. The O-ring should be flat against one end of
the foam roll, and the top of the condom should be sticking out of
the center of the other end.
(/pre>
With the scissors, make a nick in the tip of the condom, just enough
so some air can get through. Insert the foam roll into the chip
container, making sure the open end of the condom stays above the
top of the foam. Leave about 1/2" ro an inch of foam above the rim
of the can.
Use a nail or screwdriver to poke a small hole on the side of the
can near the bottom.
Optional: If desired, use a pink or red marker to draw a vagina or
lips on the foam around the center hole before covering the foam
with the condom.
Carefully stretch the condom around the rim of the can and over the
lip so it covers the foam. The lip of the can will hold the condom
in place.
To use your homemade flashlight toy, squirt some water-based,
non-greasy lube into the condom and insert your penis. Cover the
hole in the can with the tip of your finger to control the amount
of suction you get. Closing the hole will increase the suction, so
leave it open as you stroke in, and cover it on the out stroke.